Chi tiết thông tin đặc tính sản phẩm
Bộ chuyển đổi vị trí chiết áp thành tín hiệu analog MINI MCR-SL-R-UI - 2864095 Resistance/potiposition transducer Phoenix Contact
MCR potiposition transducer for conversion of potentiometer positions into a standard analog signal, 0 Ω input... 100 Ω to 0 kΩ ... 100 kΩ
Mô tả/ Product Description
Bộ chuyển đổi vị trí MINI MCR-SL-R-UI ... mỏng có chiều rộng chỉ 6,2 mm và chuyển đổi vị trí chiết áp dưới dạng phần trăm thành tín hiệu analog tiêu chuẩn. Nếu không thể sử dụng hết dải chiết áp, một công tắc trượt có thể được can thiệp bên ngoài được sử dụng để đặt giá trị cuối vị trí trên và dưới. Tín hiệu đầu ra từ 0 đến 100% dựa trên giá trị cuối cố định này./
The slim MINI MCR-SL-R-UI... potiposition transducer has a width of only 6.2 mm and converts potentiometer positions as a percentage to an analog standard signal. If the potentiometer range cannot be utilized to the full, an externally accessible slide switch is used to set the upper and lower potiposition end values. The output signal between 0 and 100% is based on this fixed end value.
Các công tắc DIP có thể can thiệp được ở bên cạnh vỏ và cho phép cấu hình các thông số sau/
The DIP switches are accessible on the side of the housing and allow the following parameters to be configured:
- Tín hiệu đầu ra/
Output signal,
- Tự động phát hiện chiết áp/
Automatic potentiometer detection,
- Thanh trượt phát hiện mạch hở và/
Open circuit detection slider and
- Kiểu đánh giá lỗi/
Fault evaluation type.
Nguồn (19,2 V DC đến 30 V DC) có thể được cung cấp thông qua các đầu kết nối trên mô-đun hoặc kết hợp với đầu nối DIN rail/
Power (19.2 V DC to 30 V DC) can be supplied through connection terminals on the modules or in conjunction with the DIN rail connector.
Ưu điểm
- Power supply possible via the foot element (TBUS)
- Automatic potentiometer detection without manual adjustment
- Error indication via diagnostic LED and analog signal
- For 100 Ω to 100 kΩ potentiometers
- potentiometer signals to create standard signals
- Configurable measuring range and output signals
- Highly-compact potentiometer transducer for electrical isolation, conversion, amplification, and filtering of
- Input and output signals can be configured via DIP switches
- 3-way isolation
- A potentiometer sub-range can be linearized via the "teach-in" switch on the device.
Bản vẽ kỹ thuật

Application drawing
Height adjustment of a lifting platform with setpoint and actual value control

Block diagram

Dimensional drawing
Chú ý
Utilization restriction |
EMC: class A product, see manufacturer's declaration in the download area |
Kích thước
Width |
6.2 mm |
Height |
93.1 mm |
Depth |
101.2 mm |
Ambient conditions
Ambient temperature (operation) |
-20 °C ... 65 °C |
Ambient temperature (storage/transport) |
-40 °C ... 85 °C |
Maximum altitude |
≤ 2000 m |
Permissible humidity (operation) |
5 % ... 95 % (non-condensing) |
Degree of protection |
IP20 |
Noise immunity |
EN 61000-6-2 When being exposed to interference, there may be minimal deviations. |
Input data
Potentiometer |
100 Ω ... 100 kΩ |
Reference voltage source |
< 3.6 V |
Output data
Voltage output signal |
0 V ... 5 V |
|
0 V ... 10 V |
|
1 V ... 5 V |
|
10 V ... 0 V |
Current output signal |
0 mA ... 20 mA |
|
4 mA ... 20 mA |
|
20 mA ... 0 mA |
|
20 mA ... 4 mA |
Max. voltage output signal |
12.5 V |
Max. current output signal |
23 mA |
Load/output load voltage output |
> 10 kΩ |
Load/output load current output |
< 500 Ω (20 mA) |
Power supply
Nominal supply voltage |
24 V DC |
Supply voltage range |
19.2 V DC ... 30 V DC (The DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, Order No. 2869728) can be used to bridge the supply voltage. It can be snapped onto a 35 mm DIN rail according to EN 60715)) |
Typical current consumption |
< 25 mA (at 24 V DC) |
Power consumption |
< 500 mW |
Connection data
Connection method |
Screw connection |
Stripping length |
12 mm |
Screw thread |
M3 |
Conductor cross section solid |
0.2 mm² ... 2.5 mm² |
Conductor cross section flexible |
0.2 mm² ... 2.5 mm² |
Conductor cross section AWG |
26 ... 12 |
General
Maximum transmission error |
< 0.2 % |
Maximum temperature coefficient |
< 0.02 %/K |
Temperature coefficient, typical |
< 0.02 %/K |
Ambient temperature (operation) |
-20 °C ... 65 °C |
Ambient temperature (storage/transport) |
-40 °C ... 85 °C |
Housing material |
PBT |
Color |
green |
Conformance |
CE-compliant |
ATEX |
II 3 G Ex nA IIC T4 Gc X |
UL, USA/Canada |
UL 508 Recognized |
EMC data
Designation |
Electromagnetic RF field |
Standards/regulations |
EN 61000-4-3 |
Typical deviation from the measuring range final value |
5 % |
Designation |
Fast transients (burst) |
Standards/regulations |
EN 61000-4-4 |
Typical deviation from the measuring range final value |
5 % |
Designation |
Conducted interferences |
Standards/regulations |
EN 61000-4-6 |
Typical deviation from the measuring range final value |
5 % |
Standards and Regulations
Electromagnetic compatibility |
Conformance with EMC directive |
Noise emission |
EN 61000-6-4 |
Connection in acc. with standard |
CUL |
Designation |
Electromagnetic RF field |
Standards/regulations |
EN 61000-4-3 |
|
EN 61000-4-4 |
Designation |
Conducted interferences |
Standards/regulations |
EN 61000-4-6 |
Electrical isolation |
Basic insulation according to EN 61010 |
Conformance |
CE-compliant |
ATEX |
II 3 G Ex nA IIC T4 Gc X |
UL, USA/Canada |
UL 508 Recognized |
|
Class I, Div. 2, Groups A, B, C, D T4 |
Conformance/approvals
Designation |
CE |
Identification |
CE-compliant |
Designation |
ATEX |
Identification |
II 3 G Ex nA IIC T4 Gc X |
Designation |
UL, USA/Canada |
Identification |
UL 508 Recognized |
|
Class I, Div. 2, Groups A, B, C, D T4 |
Designation |
Shipbuilding approval |
Identification |
BBBAA |
Certificate |
DNV GL TAA00000N1 |
Environmental Product Compliance
REACh SVHC |
Lead 7439-92-1 |
China RoHS |
Environmentally Friendly Use Period = 50 years |
|
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration” |
Classifications
eCl@ss
eCl@ss 10.0.1 |
27210120 |
eCl@ss 4.0 |
27210100 |
eCl@ss 4.1 |
27210100 |
eCl@ss 5.0 |
27210100 |
eCl@ss 5.1 |
27210100 |
eCl@ss 6.0 |
27210100 |
eCl@ss 7.0 |
27210120 |
eCl@ss 8.0 |
27210120 |
eCl@ss 9.0 |
27210120 |
ETIM
ETIM 4.0 |
EC002653 |
ETIM 5.0 |
EC002653 |
ETIM 6.0 |
EC002653 |
ETIM 7.0 |
EC002653 |
UNSPSC
UNSPSC 6.01 |
30211506 |
UNSPSC 7.0901 |
39121008 |
UNSPSC 11 |
39121008 |
UNSPSC 12.01 |
39121008 |
UNSPSC 13.2 |
39121008 |
UNSPSC 18.0 |
39121008 |
UNSPSC 19.0 |
39121008 |
UNSPSC 20.0 |
39121008 |
UNSPSC 21.0 |
39121008 |