Product Description | ||
---|---|---|
Single head system |
General specifications | ||
---|---|---|
Sensing range | 60 ... 550 mm | |
Dead band | 0 ... 60 mm | |
Standard target plate | 100 mm x 100 mm | |
Transducer frequency | approx. 380 kHz | |
Response delay | > 10 s, relay < 1 s, LEDs |
|
Indicators/operating means | ||
LED red | LED 1: overfill indication LED 4: underfill indication |
|
LED green/yellow | LED 2: overfill warning and normal operation LED 3: normal operation and underfill warning |
|
DIP switch | setting of the switch points/operating modes | |
Electrical specifications | ||
Operating voltage | 10 ... 253 V DC 20 ... 253 V AC , 47 ... 63 Hz |
|
No-load supply current | < 30 mA with UB = 30 V DC < 110 mA at UB = 10 V DC < 25 mA at UB = 220 V AC |
|
Output | ||
Output type | 3 relay outputs, normally open/closed, selectable | |
Range hysteresis | 20 mm | |
Contact loading | 253 V AC/150V DC, 3 A (ohm. load) | |
Life span | electrical: 105 switching cycles with ohmic load (3 A/253 V AC or 3 A/30 V DC) minimum contact load: 100 µA/100 mV DC mechanical: 20 x 106 switching cycles |
|
Temperature influence | < 4 % | |
Fusing | ≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly. | |
Compliance with standards and directives | ||
Standard conformity | ||
Standards | EN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 |
|
Approvals and certificates | ||
EAC conformity | TR CU 004/2011 TR CU 020/2011 TR CU 037/2016 |
|
CCC approval | self-declaration | |
Ambient conditions | ||
Ambient temperature | -20 ... 60 °C (-4 ... 140 °F) | |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
Mechanical specifications | ||
Degree of protection | IP65 | |
Connection | Female connector, V7 (7-pin), 90° Wire cross section: ≤1.5 mm2 cable diameter ∅7 ... 9 mm |
|
Material | ||
Housing | cover: PC housing: PBT threaded flange: stainless steel installation connector/cable socket: PETP |
|
Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
Mass | 700 g | |
Note | In case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs! |
System | Classcode |
---|---|
ECLASS 11.0 | 27272803 |
ECLASS 10.0.1 | 27272803 |
ECLASS 9.0 | 27272803 |
ECLASS 8.0 | 27272803 |
ECLASS 5.1 | 27272803 |
ETIM 8.0 | EC001849 |
ETIM 7.0 | EC001849 |
ETIM 6.0 | EC001849 |
ETIM 5.0 | EC001849 |
UNSPSC 12.1 | 41111960 |